Box with two sliding lidsCustom sizeSVG · PDF · DXF · AIkerf compensated
drag to rotate · scroll to zoom · shift-drag to pan
About the SlideTop Duo generator
SlideTop Duo puts two sliding lids in the same channel. The front lid slides out first through the grip curve, then the back one — like sliding doors on a cabinet.
What you can adjust
Outside or inside measurements, so the box fits the space — or the contents.
Material thickness from presets or a custom value, plus your machine's kerf.
Finger joints or flat, glued edges, with a target tooth width you can change.
A 3D preview you can spin, and a flat cutting plan with every panel named.
How it goes together
Both lids ride on the same pair of rails. The front wall is a thickness lower so either lid can pass over it, and each lid has its own grip curve so you can tell them apart.
Tips for a clean cut
Measure your sheet with calipers before you cut: material sold as 3 mm is often a little thicker or thinner, and that changes how tight the joints feel. Enter the kerf you measured on your own machine. If the first box is too tight or too loose, adjust the kerf in small steps and test again on scrap.
Frequently asked questions
Can I work in inches or centimeters?
Yes. Switch between mm, cm and inches at the top of the panel. Material thickness and kerf are always entered in millimeters.
Which file formats can I download?
SVG, PDF and DXF — all at 1:1 scale, in millimeters. AI files read the SVG or DXF straight into Illustrator.
What does the “Try other dimensions” button do?
It fills in a different set of measurements so you can see how the design changes before you enter your own.